Using The Sf-210 - Nikon SF-210 Manuel De L'utilisateur

4. Using the SF-210

This chapter describes how to load the SF-210, how to remove slides, and how to deal with
jams.
4.1 Loading the feeder
Slides to be scanned are inserted in the feed magazine. To load the magazine, open the maga-
zine cover, pull back the feed push-plate to the end of its grove, and hook it in the notch so
that it does not spring back to its original position. Place the slides in the mag a zine with the
long end of the ap er ture up and the emul sion surface facing the push plate (the images in the
slides should be reversed when viewed from the magazine side). Scanning will be considerably
simplifi ed if the slides are all inserted in the same orientation.
Magazine cover
Push plate
Feed magazine
Notch
Load mark
Slides can be loaded into the feed magazine up to the load mark. Do not attempt to fi ll the
magazine past this point. Once the feed magazine is loaded, release the push plate from the
notch and slide it back until rests against the slides.
Close the magazine cover. You are now ready to begin scan ning. For details on automatic
consecutive scanning of multiple slides, refer to the User's Manual and Nikon Scan Reference
Manual provided with the scanner.
En-8