What.to.do.if; General.conformity.declaration - Becker Centronic SensorControl SC811 Notice D'utilisation

Operating Instructions
Problem
Drive.is.not.functioning..
Transmission.control.
light.is.on
Automatic.control.com-
mands.are.not.carried.
out.
The.system.does.not.
automatically.extend.
when.should.the.sliding.
switch.be.set.to."S"
The.system.does.not.
extend.in.response.to.a.
manual.command.when.
the.sliding.switch.is.set.
to."H".or."S".
System.is.opening.when.
raining.in.spite.of.rain.
sensor.
General conformity declaration
Becker-Antriebe.GmbH.hereby.declares.that.the.device.Centronic.SensorCon-
trol.SC811.complies.with.the.basic.requirements.and.other.relevant.regulations.
of.the.EC.Directive.R&TTE.1999/5/EC.
For.use.in.the.following.countries:.EU,.CH
Subject.to.technical.changes.without.notice.
18
What to do if ...?
Cause
1..Receiver.is.outside.
of.the.radio.operating.
range.
..The.SC811.has.not.
been.programmed.into.
the.receiver.
The.sliding.switch.of.the.
hand-held/wall.trans-
mitter.is.set.to.manual.
mode."H".
1..The.sunlight.thresh-
old.value.has.not.been.
reached.
..The.wind.thresh-
old.value.is.has.been.
exceeded.
The.wind.threshold.
value.of.the.transmitter.
has.been.exceeded.
Wrong.connection.of.
rain.sensor..
Remedy
1..Reduce.the.distance.
to.the.receiver.
..Programme.the.
SC811.
Adjust.the.sliding.switch.
of.the.hand-held/wall.
transmitter.to.automatic.
mode."S".
1..Adjust.sunlight.
threshold.value.using.
the.transmitter.
..Wait.until.wind.
abates.
Wait.until.wind.abates.
Verify.wiring.