Mode Settings; Internal Display Luminance; Distance Display Unit; Measurement Display Mode - Nikon LaserForce 10x42 Manuel D'utilisation

Adjusting the focus of the internal display and diopter difference
En 1. Press the PWR button to turn on the power.
• The internal display is displayed.
Fr
2. Look in only with your right eye, rotate the internal display diopter adjustment ring, and adjust the focus
of the internal display.
3. Designate a target.
• You can correctly focus by adjusting each eye with respect to the same target.
4. Look in only with your right eye, rotate the focusing ring, and adjust the focus of your right eye.
5. Look in only with your left eye, rotate the diopter adjustment ring, and adjust the focus of your left eye.
• Correct the difference (diopter difference) in vision between the left and right.
6. Look in with both eyes and check if the focus is correct.
7. When you view a different subject, adjust the focusing ring until you obtain a sharp image.
16

Mode settings

You can change the settings of each mode. The details of each mode and the settings at the time of purchase
(factory default settings) are explained below. If you do not need to change the settings, proceed to
"Measurement" (page 20).
Mode Details
Internal display Adjust the brightness of the internal display. IL1 is the
luminance (IL) darkest, while IL4 is the brightest.
Distance display Select yards (Y) or meters (M) for the units of the
unit (F1) measurement results.
Measurement Select horizontal distance ( ) or actual distance (
display mode (F2) hidden) for the display of the measurement results.
En
Fr
Factory default setting
IL4
Yard (Y)
Horizontal distance ( )
17