Nikon LaserForce 10x42 Manuel D'utilisation page 8

Battery condition
En
Display
Fr
After power on, displays for 2 seconds only.
After power on, displays for 2 seconds only.
Displayed normally
Blinks
After blinking 3 times, automatically powers off.
Battery life
Approx. 4,000 times (at approx. 20°C/68°F)
Use this number of measurements as a reference because it changes depending on the environment such as
temperature and other factors.
* The battery supplied with this product is for operation checking. Due to natural electrical discharge, the life of this battery
will likely be shorter than that noted above.
* If water enters the battery chamber due to submersion, dry the battery chamber well, then replace the battery.
14
Description
Sufficient power available.
Power getting low.
Prepare to replace the battery.
Low. Battery should be replaced with a new one.
The battery is empty.
Replace the battery.
Adjusting the eyecups
• For eyeglass wearers, use fully retracted. If your view is secured, you can also use the two intermediate
click stops.
• For non-eyeglass wearers, use fully extended. If your view is secured, you can also use the two
intermediate click stops.
* For directions in which to turn the eyecups, please refer to the image on page 11.
Adjusting interpupillary distance
While looking at a subject through the eyepieces, gently rotate
the product body until the two images of the subject become
one as in (A).
* Take care not to get your fingers pinched when adjusting the
interpupillary distance.
En
Fr
A
15