Télécharger Imprimer la page

Mounting The Monitor; Functionality Test; Monitor Settings; Replacing The Fuse - EUFAB 16256 Manuel De L'opérateur

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6.2.6 MOUNTING THE MONITOR

Insert the monitor fixture of the monitor holder, position 10 in the
overview, see Figure 7, in the recess on the back of the monitor. Slide
the monitor completely on the fixture, until the lock engages. Insert the
angle plug of the monitor connection cable, item 2 in the overview, in the
connection socket of the monitor, Figure 8.
Fasten the monitor with the holder on the windscreen of your vehicle, as
shown in Figures 9 and 10.
Figure 8: Connection slot

6.2.7 FUNCTIONALITY TEST

Plug the camera cable and the cable of the transmitter together. Switch on the ignition of your vehicle. Insert the plug of the monitor cable into the 12 V socket of
your vehicle. If the installation has been correctly done, a blue indicator light in the left top of the frame of the monitor lights up. Now engage reverse gear. If the
transmitter and camera are connected correctly the monitor displays an image. If no image can be seen, proceed according to the fault table in Section 6.5 and
correct the fault.
If you have not detected any fault, turn off the ignition and disconnect the plug of the monitor cable. Lay and fasten the cable. Replace all the lining parts in the
boot and in the passenger compartment.

6.3 MONITOR SETTINGS

There are four buttons on the top of the monitor. Figure 11.
12 ON/OFF button
13 + button
14 Menu button
15 - button
To turn the monitor on and off press button 12. The screen menu is activated by pressing the menu button
14. Continuing to press the menu button further switches from menu point to menu point. The settings
for each menu point can be made with the + and – buttons.
To leave the screen menu, select „EXIT" by continuing to press the menu key and then press the + or –
button.

6.4 REPLACING THE FUSE

Turn the knurled screw at the tip of the 12 V connector of the monitor cable anti-clockwise until it is released from the connector and it can be removed. The fuse is
exposed and can be remove from the connector. Replace the fuse with another of the same strength and screw the knurled screw back into the connector.
Fuse: 6.0 x 30 mm, F, 1 A, 250 V

6.5 TROUBLESHOOTING

The ignition of the vehicle and the monitor
are turned on, reverse gear is engaged, but
the display remains dark. The blue indicator
light is not lit up
Suction
foot
Tab
Figure 9: Setting the holder
The plug of the monitor cable is not plugged into the 12
V vehicle socket.
The fuse in the plug of the monitor cable triggered and
must be replaced
The fuse for the 12 V vehicle socket triggered and must
be replaced.
Fixing nut
Figure 7: Monitor holder
Clamping lever
Figure 10: Holder tight
Figure 11: Monitor operation
Figure 12: Screen menu
Insert the plug of the monitor cable into the 12 V vehicle
socket
Replace the fuse in the plug of the monitor cable
Replace the fuse in the fuse box of the vehicle
Monitor fixture
Lock
9

Publicité

loading