List Of Parts And Equipment Included - Pioneer PDK-FS05 Mode D'emploi

List of parts and equipment included

Be sure to check that all the parts and equipment listed below have been included before beginning to assemble your stand.
• Note that a Philips screwdriver (not included) is required for assembly.
• Center support column x1
• Glass panel x1
Caution
The glass panel should be kept in its
packing box until you are ready to attach it
to the stand to guard against breakage.
• Long support legs x2
(Please refer to the table for Procedure 3 on page 11 for usage.)
• Short hexagonal bolts (M8 x 16 mm: black) x12
• Middle hexagonal bolts (M8 x 35 mm: black) x4
• Long hexagonal bolts (M8 x 60 mm: silver) x2
10
En
• Base x1
• Glass stays
(x2, one left and one right)
• Short support legs x2
• Hexagonal wrench x1
(Opposite side 6 mm for M8 use)
• Screws (M4 x 7 mm: silver) x4
• Screws (M4 x 10 mm: black) x2
• PDP bracket x1
• Support column covers
(x2, one left and one right)
• Cap x1
• Cable cover x1
(for attachment to
support column)
• Cable clamps x4
• Operating instructions
(This document) x1
フローティングスタンド
Floor stand
Support de base
Bodenständer
Supporto per display
Vloerstandaard
Soporte para colocar en el suelo
PDK-FS05
取扱説明書
Operating instructions
Mode d'emploi
Bedienungsanleitung
Istruzioni per l'uso
Gebruiksaanwijzing
Manual de instrucciones ucciones