Parts Included - Pioneer PDK-TS06 Mode D'emploi

Operating Instructions
Thank you for purchasing the PDK-TS06 Plasma Display Stand.
Before using this product, please read this Operating Instructions thoroughly so that you can use this product at its full functionality.
After reading, retain this Operating Instructions in an easily accessible location so that you can refer to this manual whenever you
have a problem or trouble during use.
* This plasma display stand is designed specifically for use with PIONEER 61-inch plasma displays(PDP-614MX).
Notes on Installation Work:
This product is marketed assuming that it is installed by qualified personnel with enough skill and competence.
Always have an installation specialist or your dealer install and set up the product.
PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modifica-
tion or a natural disaster.
Attention: Sales Agents and Technicians
To ensure the user's safety, be sure to select a place sufficiently strong to bear the weight of the Plasma Display
and the different units.
Installation should be performed by a minimum of three persons.
Be careful not to lose removed screws, etc.

Parts Included

* Feet (2)
Stand assembly screws M4 x 14 (8)
Specifications
Model: PDK-TS06
External dimensions: (W) 1125 x (H) 207.4 x (D) 440 mm
Weight: 8.8 kg
19.4 lbs
Oparating conditions: Temperature
Storage conditions: Temperature -10˚ to 50˚C / 14˚F to 122˚F
Display mounting screws M6 x 50 (4)
(W) 44.3 x (H) 8.2 x (D) 17.3 inchs
0˚ to 40˚C / 32˚F to 104˚F
* Bar (1)
* Operating instructions
(this instructions)
Humidity 20%~80%
Humidity 10%~90%