Operating Instructions - Flex LD 15-10 125 R Notice D'instruction D'origine

LD 15-10 125 R / LD 15-10 125 / LDE 15-10 125 R

Operating instructions

Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or damaged.
Inserting and changing the sanding
tools
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Press and hold down the spindle lock (1.).

Using the stop key, loosen the clamping

nut on the spindle in an anti-clockwise
direction and remove (2.).
Insert diamond sanding pad (A) correctly.

Screw the clamping nut (B), with flange

face up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the stop

key.
LD 15-10 125 R / LDE 15-10 125 R:

Check position of the guard.
The brush ring should protrude over
the sanding pad by approx. 0–1 mm.
If required, correct (see "Adjusting the guard
(LD 15-10 125 R / LDE 15-10 125 R)").
Insert the mains plug into the socket.

Switch on the electric power tool (without

locking the button) and leave it running
for approx. 30 seconds. Check for
imbalances and vibrations.
Switch off the electric power tool.

Adjusting the handle
Loosen rotary knob for adjusting the

handle by turning it approx. 2 revolutions
anti-clockwise.
Place handle in the required position

(15° notch).
Ensure that handle engages correctly!
Tighten rotary knob for adjusting the

handle clockwise.
19