Maintenance And Care; Disposal Information; Declaration Of Conformity - Flex LD 15-10 125 R Notice D'instruction D'origine

Brush ring (LD 15-10 125 R /
LDE 15-10 125 R)
The guard features a brush ring. This ring
has two functions:
– As the ring projects above the surface of
the sanding pad, it is the ring which comes
into contact with the work surface first.
As a result, the sanding pad is brought
parallel to the work surface before the
sanding tool comes into contact with the
work surface. This avoids a sickle-
shaped depression caused by the edge
of the sanding pad.
– The ring retains the dust until it is
extracted by the dust extractor.
If the brush ring is damaged or excessively
worn, it should be replaced.
A replacement brush set is available
from any FLEX - customer service centre.
Rubber extraction ring
(LD 15-10 125)
If the rubber extraction ring is damaged
or excessively worn, it should be replaced.
A replacement extraction ring is available
from any FLEX customer service centre.

Maintenance and care

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
WARNING!
Do not use water or liquid detergents.
Regularly blow out the housing interior

and motor with dry compressed air.
Clean the guard and pivoted edge

segment using dry compressed air.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
NOTE
During the warranty period do not loosen
the screws on the motor housing.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
22
LD 15-10 125 R / LD 15-10 125 / LDE 15-10 125 R
Spare parts and accessories
Other accessories, in particular insertion
tools, can be found in the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable
by removing the power cord.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European
Directive 2012/19/EU on Waste Electrical
and Electronic Equipment and transposition
into national law used electric power tools
must be collected separately and recycled
in an environmentally friendly manner.
NOTE
Please ask your dealer about disposal
options!

-Declaration of Conformity

We declare under our sole responsibility
that the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 60745 in accordance with the regu-
lations of the directives 2014/30/EU,
2006/42/EC, 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Eckhard Rühle
Manager Research &
Development (R & D)
22.05.2018
FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Klaus Peter Weinper
Head of Quality
Department (QD)