König SAS-IPCAM2 Série Manuel De L'utilisateur page 5

Technical data
SAS-IPCAM200
1/4" 720p
Image sensor progressive scan
CMOS
SNR ≥ 39 dB
Lens angle 3.6 mm, F1.4/56.14
IR LEDs 1
Frequency
850 nm
(IR LED)
Night vision 5 m
Resolution 720p / VGA / QVGA
Frame rate 30 fps / 24 fps
Memory card Maximum 128 GB
Power 5 V ± 0.3 V
Consumption 3.2 W
Temperature -10 °C ~ 50 °C
Humidity < 90%
Weight 135 g
Safety
• To reduce risk of electric shock, this product should only be
opened by an authorized technician when service is required.
• Disconnect the product from the mains and other equipment if
a problem should occur.
• Read the manual carefully before use. Keep the manual for
future reference.
• Only use the device for its intended purposes. Do not use the
device for other purposes than described in the manual.
• Do not use the device if any part is damaged or defective. If the
device is damaged or defective, replace the device immediately.
• The device is suitable for indoor use only. Do not use the device
outdoors.
• Do not expose the product to water or moisture.
Cleaning and maintenance
Warning!
• Do not use cleaning solvents or abrasives.
• Do not clean the inside of the device.
• Do not attempt to repair the device. If the device does not
operate correctly, replace it with a new device.
• Clean the outside of the device using a soft, damp cloth.
SAS-IPCAM210 SAS-IPCAM220
1/4" 720p 1/4" 720p
progressive scan progressive scan
CMOS CMOS
≥ 41 dB ≥ 39 dB
3.6 mm, 3.6 mm,
F1.4/56.14 F1.4/56.14
12 2 (array LEDs)
850 nm 850 nm
10 m 15 m
720p / VGA / 720p / VGA /
QVGA QVGA
25 fps 25 fps
Maximum 128 GB Maximum 128 GB
5 V ± 0.3 V 12 V ± 0.3 V / 2 A
3 W 3.5 W
- 20 °C ~ 70 °C -20 °C ~ 70 °C
90% 100%
625 g 340 g
Warranty
Any changes and/or modifications to the product will void the
warranty. We cannot accept any liability for damage caused by
incorrect use of the product.
Disposal
• The product is designated for separate collection at an
appropriate collection point. Do not dispose of the product with
household waste.
• For more information, contact the retailer or the local authority
responsible for waste management.
Documents
The product has been manufactured and supplied in compliance
with all relevant regulations and directives, valid for all member
states of the European Union. The product complies with all
applicable specifications and regulations in the country of sales.
Formal documentation is available upon request. The formal
documentation includes, but is not limited to the Declaration of
Conformity, the Material Safety Data Sheet and the product test
report.
Disclaimer
Designs and specifications are subject to change without notice. All
logos, brands and product names are trademarks or registered
trademarks of their respective holders and are hereby recognized as
such.
5
English