Unpacking; Installation - Gram AM Série Manuel D'utilisation

• A balance Series AM.
• A transparent dust cover.
• A weighing pan.
VERY IMPORTANT: Keep the original package. It could be useful in the future
in transporting the balance.

UNPACkINg

1. Remove the weighing pan from the package.
2. Remove the balance and place it on a flat, firm and stable surface.
3. Install the weighing pan, so that the four platter screws fit in the top
holes of the balance.

INSTALLATION

1. Level the balance by turning the four adjustable feet, the bubble level
located on rear side of the balance must remain in the centre of circle.
2. Connect the balance to the supplied AC/Adaptor 220 V 50.
3. Keep the balance connected for 8 hours to fully charge the rechargeable
battery (This action is only necessary for the first installation or if the
balance was stored for several months).
4. Press the ON-CERO key. The balance performs with a self-test, after a
few seconds the display will show zero value.
5. To obtain maximum accuracy, it is necessary to maintain the balance
6