Assembly - Husqvarna 122C Manuel D'utilisation

Masquer les pouces Voir aussi pour 122C:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 118
Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is sufficient airflow.
Do not smoke near the fuel or the engine.
Do not put warm objects near the fuel or the engine.
Do not add the fuel when the engine is on.
Make sure that the engine is cool before you refuel.
Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
Make sure there are sufficient airflow when refueling
and mixing fuel (petrol and two-stroke oil) or draining
the fuel tank.
Fuel and fuel vapor are highly flammable and can
cause serious injury when inhaled or allowed to
come into contact with the skin. For this reason,
observe caution when handling fuel and make sure
there is sufficient airflow.
Tighten the fuel tank cap carefully or a fire can
occur.
Move the product at a minimum of 3 m (10 ft) from
the position where you filled the tank before a start.
Do not put too much fuel in the fuel tank.
Make sure that a leak cannot occur when you move
the product or fuel container.
Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an open
flame.
Only use approved containers when you move the
fuel or put the fuel into storage.
Empty the fuel tank before long-term storage. Obey
the local law on where to dispose fuel.
Clean the product before long-term storage.
Remove the spark plug cap before you put the
product into storage to make sure that the engine
does not start accidentally.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
cable from the spark plug before you
assemble the product.
8
Read the warning

Assembly

Before you assemble the
Remove the spark plug
Stop the engine, make sure that the cutting
attachment stops and let the product cool down
before you do the maintenance.
Disconnect the spark plug cap before you do the
maintenance.
The exhaust fumes from the engine contain carbon
monoxide, an odourless, poisonous and very
dangerous gas that can cause death. Do not run the
product indoors or in closed spaces.
The exhaust fumes from the engine are hot and can
contain sparks. Do not run the product indoors or
near flammable material.
Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
injury or death. Do not change the product. Always
use original accessories.
If the maintenance is not done correctly and
regularly, there is an increased risk of injury and
damage to the product.
Only do the maintenance as this operator's manual
recommends. Let an approved Husqvarna service
agent do all other servicing.
Let an approved Husqvarna service agent do
servicing on the product regularly.
Replace damaged, worn or broken parts.
Refer to the instructions for the cutting attachment
for correct procedure to install the trimmer cord and
correct cord diameter.
Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
941 - 007 - 24.08.2021

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

122lk

Table des Matières