Jimmy HW8 Mode D'emploi page 9

stopping work, remove dirty water tank upper cover, pour out the dirty water and dirt in the dirty
water tank, wash the dirty water tank, support frame, float, filter frame and filter foam with clean
water. Dry the above parts after washing, then put them back into the dirty water tank, and then
assemble the dirty water tank into the machine to continue to use. (Fig 11)
Brushroll cleaning
Hold brushroll window with finger and pull upward to take it out. Pull left side of brushroll to
take it out. Use dry cloth to wipe brushroll housing and cut off the hair tangled around brushroll.
Wash the brushroll window and brushroll in clean water. After cleaning, assemble brushroll and
brushroll window back to machine. (Fig 12)
Note:
If the cleaner will not be used soon after cleaning,completely dry the dirty water tank, dirty water tank cover,
filter, filter frame, brushroll, brushroll window, machine and then assemble the machine for storage, in order to
prevent the bacteria from breeding in the humid environment and producing odor.
Maintenance and Storage
1. it is recommended to clean the dirty water tank, filter, brushroll and brushroll window after
each use. If the dirty water reaches MAX line, please drain the dirty water tank immediately
otherwise the machine cannot operate normally. After the accumulated use time of the filter
reaches 30-50 hours (various basing on filter status),replace the filter to avoid affecting machine
performance. Filter can be bought from local distributor.
2. After the use of this product, place it on charging base and ensure the product standing
upright to reduce accidental contact and tilt.
3. when pack and store the machine, if it is necessary to disassemble battery pack, remove
back cover, hold the battery pack and pull to take it out. (Fig 13)
4. when the machine is long idled, place it in a cool and dry place, avoid direct sunlight or wet
environment.
7