Jimmy HW8 Mode D'emploi page 8

Machine charging
Put the machine into the charging stand, connect one end of the adapter to the charging stand,
and the other end to the power socket (when charging, the indicator light at the handle is red,
the display screen shows the percentage of battery power, and the light rotates in a circle; When
the charging is completed, the indicator light on handle is green, the display screen shows
100% electricity, and the light at the same time is always on white). When charging, the machine
should be placed on the charging base, close to the corner to avoid tripping and other injuries.
Note:
1. If the product is long idled after purchase, please use the adapter to charge the battery about every three
months, to avoid affecting the battery life.
2. Do not leave the charger on power socket all the time to prevent children from touching it by mistake.
3. When using for the first time, the capacity of the battery pack of the floor washer may not be full. Please
fully charge the battery, fully discharge the battery pack, and then charge it for the second time, to improve the
life of the battery.
4. For the first three times of use, it is recommended to charge the floor washer for 12 hours each time. After
complete charging and discharging for three times, the floor washer can be charged according to the normal
charging time.
Brushroll self cleaning
Before self-cleaning, Drain the dirty water tank, place the machine on the charging base, insert
the charger into the socket, keep at least 1/2 of the water in the clean water tank, press the
mode button for 3 seconds, the machine will enter self-cleaning mode, the self-cleaning indicator
on the LED display will blink, the front nozzle will spray water continuously for 5 seconds, then
the brushroll will rotate continuously for 10 seconds for self-cleaning, and finally the machine will
run continuously for 30 seconds to pick up dirty
water into dirty water tank , the machine will
repeat this cleaning process for three time to
complete self cleaning. And the machine enters
charging mode (Fig 10)
Note:
Drain the dirty water tank before and after self-
cleaning.
Cleaning and Maintenance
Clean dirty water tank
When the dirty water tank is full, the water level
detecting float is activated, the indicator light
stays green, and the water full indicator on the
display screen blinks continuously. The cleaner
stops working to remind the user to clean the
dirty water tank as soon as possible. After
6
11
Dirty water tank MAX line tank
Take off
brushroll window
Take off
brushroll
12
Back cover
13
Clean dirty water tank
Clean brushroll
Battery
Pack