Jimmy HW8 Mode D'emploi page 6

Disassemble and assemble clean water tank
To take off clean water tank, press clean water tank release button and clean water tank will
pop out from back body, remove water tank. To assemble clean water tank, Place cap on clean
water tank bottom into the water inlet slot on back body, press clean water tank until a "click"
sound is heard.(Fig 5)
Disassemble and assemble brushroll window and brushroll
1.To take off brushroll window, put finger on brushroll window holder position and pull upward to
remove brushroll window. To assemble brushroll window, align the clips on two sides of brushroll
window with the slots on two sides of floorhead. Press brushroll window until a "click" sound is
heard.
2.Disassemble/assemble brushroll: Pull out brushroll left cap with finger to take brushroll out.
Hold brushroll cap, slide brushroll left side into gear , place brushroll into nozzle.(Fig 6)
Products USE
LED screen
Battery power digital display
Lights
Battery power icon display
Battery power
percentage display
Dirty water
Self cleaning indicator
Clean water tank empty indicator
tank full indicator
1.Lights: White colour, shows machine Max and Standard mode(Full lights in Max/Half lights in
Standard).
HW8: Brushroll rotating speed is different in Max and Standard mode.
HW8 Pro: Vacuum suction power is different in Max and Standard mode.
2.Battery power digital and percentage display: Displays current battery power left.
3.Battery power icon display: Battery power warning(Lights are white when battery power is
higher than 20%, lights turn red and blinks when battery power is lower than 20%).
4