JUNO JKSN807F5 Notice D'utilisation page 23

Use sensor field:
To activate the outer ring: touch the
sensor field. The indicator comes on.
To activate more outer rings: touch the
same sensor field again. The subsequent
indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
When you activate the zone but
do not activate the outer ring the
light that comes out from the
zone may cover the outer ring. It
does not mean that the outer
ring is activated. To see if the
ring is activated check the
indicator.
Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch until the correct heat
setting comes on. After 3 seconds
comes on.
To deactivate the function: touch
Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the cooking zone then set the
function. You can set the heat setting
before or after you set the function.
To set the cooking zone: touch
and again until the indicator of a necessary
cooking zone comes on.
To activate the function or change the
time: touch
time (00 - 99 minutes). When the indicator
of the cooking zone starts to flash slowly
the time counts down.
To see the remaining time: set the
cooking zone with
cooking zone starts to flash quickly. The
display shows the remaining time.
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
When the time comes to an
end, the sound operates and 00
flashes. The cooking zone
deactivates.
To stop the sound: touch
Minute Minder
You can use this function as a Minute
Minder when the hob is activated and the
cooking zones do not operate (the heat
setting display shows
To activate the function: touch
Touch
When the time comes to an end, the sound
operates and 00 flashes.
To stop the sound: touch
The function has no effect on
.
the operation of the cooking
zones.
Lock
You can lock the control panel while
cooking zones operate. It prevents an
accidental change of the heat setting.
Set the heat setting first.
To activate the function: touch
again
comes on for 4 seconds. The Timer stays
on.
To deactivate the function: touch
The previous heat setting comes on.
or of the timer to set the
. The indicator of the
and touch
).
or of the timer to set the time.
23
. The
.
.
.
.
.