IKUSI MAC 201 Manuel D'utilisation page 38

Unit installation and confi guration
Restoring factory settings
Locate and select the option FACTORY SET-
6)
TINGS to restore the factory settings of the
unit.
Select the option DELETE to delete all the modifi -
cations entered in the confi guration by the installer
or operator of the unit.
Setting the signals
NOTE
The unit can switch the input signals; alter their brightness, contrast and satura-
tion conditions; and adjust the output carrier in RF.
Locate and select the option SETTINGS.
1)
Confi guring the input signals
Locate and select the option INPUT.
1)
Locate and select the option CH1:*****
a)
BRIGHTNESS to check the type of input
signal, the video and audio detection, and
confi gure the brightness of the video signal
(1 to 255).
Locate and select the option CONT1
b)
SATURATION to confi gure the contrast
and saturation of video signal 1 (1 to 255).
Locate and select the option VOL. INPUT
c)
1 to confi gure the attenuation of audio
signal 1 in dB (1 to 40)
Locate and select the option SHARPNESS
d)
1 to confi gure the sharpness of video sig-
nal 1 (HIGH, MEDIUM SOFT or NONE).
Locate and select the option CODING 1.
e)
This confi gures the coding parameters:
MPEG2 or MPEG4 LAYER2.
Locate and select the option ASPECT
f)
RATIO. The possible aspect ratio values
are 1:1, 4:3 and 16:9.
38
/ Main menu