Alesis PA80 Guide D'utilisation page 6

Mixer, Rear Panel
1. Power Switch: Use this switch to power the mixer on/off.
2. Power Connector: The integrated power cord is located here.
3. Fuse Holder: The fuse should only be changed by a qualified technician. If the fuse continues to blow
after replacing, discontinue use of this mixer until it is repaired.
4. Speaker Output: Connect the two included non-powered (passive) speakers to these outputs. If using
4 speakers at the same time, use 8–16 Ω speakers. When using only one speaker, use a 4–8 Ω
speaker.
Speaker, Rear Panel
1. Input: Connect the Speaker Output of the mixer here.
Link: Connect this output to the input of another 8–16 Ω passive
2.
speaker.
6
1
2
3
4
1 2