Establishing And Testing The Wireless Connection - BRÖTJE RGTF Instructions De Montage

5.3 Establishing and testing the
wireless connection (wireless
transmitter for outside
temperature sensor FSA)
Fig. 7: Key and LED on wireless transmitter for outside temperature sensor FSA
136 230 06.11
Establishing the wireless connection
Note: Carry out the wireless connection with loose components near the FE receiv-
er to ensure that all components are within range.
In order to establish the wireless connection between wireless receiver FE and
wireless transmitter for outside temperature sensor FSA, the following conditions
must be met:
- the FE receiver must be correctly connected at the boiler
- the batteries of the wireless transmitter FSA must be inserted correctly
The wireless connection to the wireless transmitter for outside temperature sen-
sor FSA is established as follows:
1. Hold down the key on the FE receiver until the LEDs
key
C0006247
2. Keep the key on the wireless transmitter for outside temperature sensor FSA
pressed for at least 8 seconds until the LED flashes quickly (Fig. 7)
For more information on changing parameters, see the Boiler installation instruc-
tions. For information on the wireless transmitter for outside temperature sensor
FSA, see the Wireless transmitter for outside temperature sensor FSA installation in-
structions.
Note: Connection has been made when the LED
receiver and then illuminates permanently.
Testing the wireless connection
The wireless connection to the wireless transmitter for outside temperature sen-
sor FSA is tested as follows:
1. Hold down the key on the FE receiver until the LEDs
2. Press the key on the wireless transmitter for outside temperature sensor FSA
for approx. 3-8 seconds until the LED flashes slowly
Note: If the connection is working, the LED on the wireless receiver FE illuminates
briefly every 10 s
Wireless receiver FE
Commissioning
and illuminate
LED
flashes a few times on the FE
and illuminate
GB
27