Remote Control Keys; Safety Information - Philips 29PT8521/12 Mode D'emploi

Remote control keys

& Standby
To set the TV to standby mode. To switch the TV
b
set on again, press
é Sleeptimer
To select the length of time before the set
automatically switches to standby (from 0 to 240
minutes).
" Select peripherals (p.10)
Press several times to select the required EXT
connector.
' Teletext keys (p. 8)
( Dual screen (according to the version)
To activate/disable the display on 2 screens. The
second screen displays teletext.
§ Menu
To call up or exit the menus.
è Cursor / Format
These 4 keys are used to navigate through the
menus. (p. 9)
! Volume
To adjust the sound level.
ç Mute
To mute or restore the sound.
0 Screen information
To display / remove the programme number, the
name (if it exists), the time, the sound mode and
the time remaining on the timer. Hold down for 5
seconds to permanently display the programme
number on the screen.

Safety Information

• Plug the TV into a 220V – 240V AC, 50 Hz supply.
• Disconnect mains plug when :
– the red light below the TV screen is flashing continuously.
– a bright white line is displayed across the screen.
– there is a lightning storm.
– the set is left unattended for a prolonged period of time.
• Cleaning the TV screen. Never use abrasive cleaning agents. Use a slight damp chamois leather or soft cloth.
• No naked flame sources, such as lighted candles, should be placed on top of the TV or in the vicinity.
• Do not place your TV set under direct sunlight or heat.
• Do not cover or block the TV as it could lead to overheating.
• Leave at least 5 cm around each side of TV set to allow for proper ventilation.
• Avoid placing your set (e.g. near the window) where it is likely to be exposed to rain or water.
• Battery Usage CAUTION – To prevent battery leakage that may result in bodily injury, property damage, or damage to
the unit:
– Install all batteries correctly, with + and – aligned as marked on the unit.
– Do not mix batteries (old and new or carbon and alkaline, etc.).
– Remove batteries when the unit is not used for a long time.
Useful Tips
• Do not leave your set on standby mode for a prolonged
period of time. Switch off set to allow it to be demagnetised. A demagnetised set supports good picture quality.
• Do not shift or move the set around when it is switched on. Uneveness in colour in some parts of the screen may occur.
• Never attempt to repair a defective TV yourself. Always consult a skilled service personnel.
@ # 0 9
, P or .
1 Sound mode
Used to force programmes in
to or, for bilingual programmes, to
Stereo Mono
choose between
Dual I
The indication is red when in forced position.
Mono
2 Surround Sound
To activate / deactivate the surround sound effect. In
stereo, this gives the impression that the speakers are
further apart. For models equipped with Virtual Dolby
Surround*, you can experience Dolby Surround Pro
Logic sound effects.
3 Smart picture and sound
Used to access a series of predefined picture and sound
settings.
The position relates to settings selected from the
personal
menus.
4 Teletext call (p. 8)
5 Programme selection
To access the next or previous TV channel from the
list of Favourite Programmes (see p. 5).
6 Digit keys
Direct access to the programmes. For a 2 digit
programme, enter the 2nd digit before the dash
disappears.
7 Active Control (according to the version)
Optimizes the quality of the picture according to the
quality of reception.
and
Stereo Nicam
or .
Dual II
3