Bosch EasyComfort I 6 TDS60 Série Notice D'utilisation page 18

3x
Cleaning & Maintenance
3x
2h
300 ml
18
B O SC H
5. Auto switch off
For your safety and to save energy, the appliance switches
off automatically when it has not been used for 8 minutes.
Three beeps will be heard, and all indicator lights (1, 2, 3,
4) will flash.
1 To switch the steam station back on, press the steam
release button (14) again.
1. Descaling process
Important: to keep your appliance in good condition
for a long time, you should carry out the descaling
process after a period of use. The "Calc'nClean"
indicator light (2) will flash and three beeps will be
heard, indicating that the process should be
performed.
Descaling the boiler
1 Press the button (1) to switch the appliance off. Unplug
the appliance and let it cool down for at least 2
hours.
2 Empty the water tank.
3 Remove the iron from the pad (12).
4 Unscrew and remove the boiler cap (8) and take it out.
Empty the boiler completely.
5 Fill the boiler with approximately 300 ml of tap water.
Close the boiler cap and shake the base unit for a few
moments. Then, empty it completely.
Important: To obtain the best result, we recommend
that this operation be performed twice.
Before re-closing, make sure no water remains in the
boiler.
6 If your appliance is equipped with scale collector
(8*), it must be washed (see the "Descaling the scale
collector" section).
7 Replace and tighten up the cap.
* Model dependent