Replacing The Belt - Titan PowrBeast 4700 Mode D'emploi

MAINTENANCE
7.10

REPLACING THE BELT

Before replacing the belt on your unit, make
sure you have performed the "Pressure Relief
Procedure" as illustrated in the Operation section
of this manual. DO NOT attempt this repair while
the unit is running.
The graphics below show a unit with a gas
i
engine. All instructions given in this section will
apply to both gas engine models and electric
motor models except where noted.
1. Remove the three screws and washers (1) that secure the
top shroud (2) to the cart frame. Remove the shroud.
2. Remove the front screw (3) and the bottom screw (4) that
secures the lower shroud to the main unit. Remove the
entire shroud.
3
4
3. Carefully insert the driver end of a screwdriver in between
the belt and upper pulley as shown (fig. 31).
30
4. With the screwdriver in place, use your other hand to
manually turn the belt and pulleys counterclockwise.
Allow the screwdriver to follow the motion of the pulley
and pry the belt outward at the same time. Continue to
turn the pulley approximately 1/2 turn and the belt will
slide off the upper pulley with the help of the screwdriver.
PINCH HAZARD. Make sure your fingers remain
clear of the contact area between the screwdriver
and the pulley. Do not allow your fingers to get
between the belt and pulley as it turns.
BURN HAZARD. Make sure the gas engine has
had time to sufficiently cool before touching it.
1
2
REINSTALLATION
1. Loop the the new belt over the top pulley until the belt
engages the pulley groove.
2. Allow the belt to hang from the top pulley. With your
hand, hold the belt in place in approximately the 3:00
position on the lower pulley groove.
3. Use your other hand to manually turn the upper pulley
clockwise. Allow the hand holding the belt on the lower
pulley to follow the motion. The motion of the pulley and
the placement of your hand over the belt on the lower
pulley will allow the the belt to slide into place on the
lower pulley.
Make sure the belt is not pinched or twisted in
any way.
Attention
4. Reverse steps 1-2 to reassemble the unit.
POWRBEAST