Operation; 8�1 Display Current Temperature And Switch Point Sp2; 8�2 Operating Indicators - Autosen AS001 Notice D'utilisation

8 Operation

After every power on all LEDs light and go out again step by step (during this time
the outputs are closed if configured as normally open)� The unit is then ready for
operation�
In case of power failure or interruption all settings remain�
8.1 Display current temperature and switch point SP2
► Press the button
> The unit indicates the current temperature and the current setting of the switch
point (SP2) in steps of 10 °C for approx� 5 s�
Row of LEDs red = current temperature T in °C�
LED 0
T 0���9
LED green or orange = current switch point SP2 in °C
LED 0
SP2 2���4 5���14 15���24 25���34 35���44 45���54 55���64 65���74 75���80
LED green if OUT = OFF; LED orange if OUT = ON
8.2 Operating indicators
0 1 2 3 4 5 6 7 8
0 1 2 3 4 5 6 7 8
0 1 2 3 4 5 6 7 8
briefly�
0 1 2 3 4 5 6 7 8
0���1 0���2
10���19 20���29
1 2 3
Green LED bar: current flow within the display
range�
Indication of the switch point flow (SP1):
[x10°C]
- LED orange: output closed�
- LED red: output open�
LED 9 flashes: current flow above the
representation range�
[x10°C]
LED 0 flashes: current flow far below the display
range�
[x10°C]
[x10°C]
0���3
30���39
4 5 6
UK
0���9
���
90���99
7 8 9
---
31