7�5 Set Switch Point Sp2 For Temperature - Autosen AS001 Notice D'utilisation

The unit is now adapted to your flow conditions� It returns to the operating mode,
the display should now show example 1�
The adjustment affects the switch point: it is increased proportionally (maxi-
mum up to LED 7)�
7.5 Set switch point SP2 for temperature
► Press the button
> The unit indicates the current temperature and the current setting of the switch
point (SP2) in steps of 10 °C for approx. 5 s (→ 8.1).
0 1 2 3 4 5 6 7 8
LED green if OUT = OFF; LED orange if OUT = ON�
► Briefly press
> The current setting of the switch point is indicated in steps of 1 °C and can be
changed�
0 1 2 3 4 5 6 7 8
LED green if OUT = OFF; LED orange if OUT = ON�
In addition, the current temperature is indicated in steps of 10 °C by red LEDs�
► Press or
flashing LED (units digit) by one position in the indicated direction�
0 1 2 3 4 5 6 7 8
After LED 9 has been reached the cycle starts again at LED 0; the continuously
lit LED (tens digit) moves one position to the right (when setting is made with
)�
0 1 2 3 4 5 6 7 8
28
briefly�
[x10°C]
again within 5 s�
[x10°C]
as often as required� Each press of the pushbutton shifts the
[x10°C]
[x10°C]
Red LEDs = temperature,
green or orange LED = switch point�
Lit LED = tens digit (10 times X °C),
flashing LED = units digit (X °C)�
Here: 51 °C�
0 1 2 3 4 5 6 7 8
0 1 2 3 4 5 6 7 8
[x10°C]
[x10°C]