Hardware; Back Panel; Front Panel - Focusrite OctoPre MkII Dynamic Mode D'emploi

Hardware

Back Panel

The back panel provides the all of the input and output connections on the OctoPre MkII Dynamic.
7
1 8 x Combo inputs for Inputs 1 - 8. Mic via XLR or Line via Jack*
2 8 x Line outputs (1 - 8)*
3 2 x Optical input sockets **
4 2 x Optical output sockets **
5 1 x BNC Word Clock input connector
6 1 x BNC Word Clock output connector
7 1 x IEC Power input socket
* Either 1/4 inch TRS (balanced) or TS (unbalanced) Jack connectors can be used.
** @ sample rates of 44.1 / 48 kHz use either output port 1 or port 2 for 8 channels - ADAT (a copy is sent to both ports)
@ sample rates of 88.2 / 96 kHz use output port 1 and 2 for 2 x 4 channels - ADAT SMUX.

Front Panel

1
9
1 Preamp Gain and Compression Compress and More controls for Inputs 1 - 8
2 Separate 5 LED meter for each input channel -42, -18, -6, -3, 0 dBFS. (NOTE: Metering is post preamp and compression)
The Mic 48V Phantom Power switches with LEDs for Channels 1-4 and 5-8
3
4 Inst Instrument switch with LEDs for inputs 1 and 2
Sample Rate switch with separate LEDs for each sample rate
5
6 Clock Source switch with separate LEDs for sync source / status
AD DA Switch to route ADAT input to line outputs
7
8 Power switch with LED - LED is lit when the unit receives power and is turned on
9 Removable rack-ear covers - remove to install unit into a 19 inch rack
6
5
2
3
4
1
2
4
6
3
5
8
7
9
5