Output Shaft; Maintenance And Cleaning; Permitted Ika ® Stirring Tools - IKA RW 47 D Mode D'emploi

The chuck (E) (Fig. 2) and off-drive shaft allow stir-
ring elements with shank diameters of 3 mm to
16 mm to be clamped. Shank diameters of up to
13 mm can be inserted through the hollow shaft
The stirrer is maintenance-free.
Only clean IKA appliances using these IKA
®
proved cleaning agents:
Dirt Cleaning agent
Dyes Isopropanol
Building materials Water containing
detergent,
Isopropanol
Cosmetics Water containing
detergent,
Isopropanol
Food Water containing
detergent,
Fuels Water containing
detergent,
Other materials Please consult IKA
- Wear protective gloves when cleaning the de-
vices.
- Do not place electrical appliances into the
cleaning agents for cleaning purposes.
- Do not allow moisture to get into the appliance
when cleaning.
- Please consult IKA before using any cleaning
®
or decontamination methods, other than those
recommended here.
R 2305 Propeller stirrer 4fl
R 2302 Propeller stirrer 4fl
R 1385 Propeller stirrer 3fl
R 1388 Propeller stirrer 3fl
R 1313 Turbine stirrer
R 1300 Dissolver stirrer
R 1301 Dissolver stirrer

Output shaft

to just before the top edge of the inside casing.
You must ensure that the stirring shank is securely
clamped in the chuck.

Maintenance and cleaning

- When cleaning the unit, take particular care
ap-
®
- Make certain that the hexagon head nut (part
Spare parts order
When ordering spare parts, please give:
- Machine type
- Manufacturing number, see type plate
®
- Item and designation of the spare part, see
Repair
In case of repair the device has to be cleaned
and free from any materials which may constitu-
te a health hazard.
If you require servicing, return the appliance in
its original packaging. Storage packaging is not
suffi cient. Please also use suitable transport pa-
ckaging.
Permitted IKA Stirring tools
®
Max. speed rpm
1300 R 1302
600 R 1303
800 R 1376
400 R 2311
800 R 1333
2000 R 1393
800
not to bring substances containing oil or gre-
ase into contact with the running surfaces of
the cone pulley and the friction wheel. This
would substantially reduce the frictional coef-
fi cient resulting from the pairing of the friction
wheel and cone pulley materials, and would
impair power transmission in the unit.
no. 153 of spare parts diagram) is suffi ciently
tightened in order to prevent the shifting of
the motor plate and thus the speed as well.
www.ika.com, spare parts diagram and spa-
re parts list
Dissolver stirrer
Dissolver stirrer
Surface stirrer
Surface stirrer
Anchor stirrer
Worm stirrer
1000
2000
800
600
800
1000
16