Assembly - Husqvarna LE121P Manuel D'utilisation

• Keep batteries in storage away from metal objects
such as nails, coins, jewellery.
Battery charger
The battery chargers, QC, are only used for charging of
Husqvarna replacement batteries.
• Minimise the risk of electric shock or short circuit as
follows: Never insert any object into the charger's
cooling slots. Do not try to dismantle the battery
charger. Never connect the charger terminals to
metal objects. Use approved and intact wall sockets.
• This machine produces an electromagnetic field
during operation. This field may under some
circumstances interfere with active or passive
medical implants. To reduce the risk of serious or
fatal injury, we recommend persons with medical
implants to consult their physician and the medical
implant manufacturer before operating this machine.
• Regularly check that the battery charger connection
wire is intact and that there are no cracks in it.
• Never carry the battery charger using the cord and
never pull out the plug by pulling the cord.
• Keep all cables and extension leads away from
water, oil and sharp edges. Make sure the cable is
not jammed in doors, fences or the like. Otherwise it
can cause the charger to become live.
• Never clean the battery or the battery charger with
water.
• The battery charger can be used by children aged
from 8 years and above and persons with reduced
physical, sensory, or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.
• Do not charge non-rechargeable batteries in the
battery charger.
• Do not use the battery charger close to corrosive or
flammable materials. Do not cover the battery
charger. Pull out the plug to the battery charger in
the event of smoke or fire.
Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: To prevent accidental start
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
428 - 002 -
• Do not use a faulty or damaged battery charger or
battery.
• Only charge the battery indoors and protected from
direct sunlight and do not charge the battery in any
wet conditions.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
• To prevent accidental start during maintenance, turn
the safety key to 0 and remove the battery. Wait at
minimum 5 seconds before you start the
maintenance.
• Do the maintenance work correctly to increase the
lifetime of the product and decrease the risk of
accidents. Let an approved service agent do the
professional repairs. Speak to your nearest service
agent for more information.
• Only do the maintenance work written in this
operator's manual. More extensive work must be
done by an approved service agent.
• Put on heavy duty gloves when you use the cutting
equipment. The blade is very sharp and cuts can
easily occur.
• Keep the cutting edges sharp and clean for the best
and safest performance.
• Let your service agent regularly examine the product
and make necessary adjustments and repairs.
• Replace damaged, worn or broken parts.
• Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
• When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
not approved cannot get access to the product,
battery or battery charger.
SAVE THESE
INSTRUCTIONS

Assembly

To assemble the handle
CAUTION: Make sure that the cable run
along the inner part of the handlebar. Make
sure that the cable do not get pinched when
you assemble the handlebar.
9