Publicité
STEP 39: (SEE FIGURE 39)
•
Remove the engine pulley keeper from the side of
the tractor frame by removing the washer and nut
that secure the keeper. Attach the new pulley keeper
supplied with the snow thrower, reusing the original
bolt, washer and nut.
NOTE: Some tractors may already be equipped with a
pulley keeper that is identical to the new one supplied.
•
Attach the clutch/idler assembly to the tractor frame
as follows. Hook the assembly's notched arms onto
the two shoulder bolts you assembled to the inside
of the tractor frame. Lift the front of the assembly and
attach it to the R.H. and L.H. hanger brackets using
two pivot lock pins (GG) and 1/8" hairpin cotters (EE).
NEW ENGINE PULLEY KEEPER WITH
ORIGINAL BOLT, NUT AND WASHER
PIVOT LOCK PIN (GG)
(use second hole)
1/8" HAIRPIN COTTER (EE)
FIGURE 39
STEP 40: (SEE FIGURE 40)
•
Assemble the short "V" belt onto the engine pulley
and then onto the large pulley on top of the clutch/idler
assembly. The belt must be placed to the inside of the
engine pulley keeper, the idler pulley and the keeper
bolt located beside the large pulley.
IMPORTANT: Do Not assemble the "V" belt around the
outside of the engine pulley keeper or the keeper bolt.
•
Go to step 48 on page 22.
CLUTCH/IDLER ASSEMBLY
ENGINE
PULLEY
KEEPER
IDLER
PULLEY
FIGURE 40
19
Left Side
of Tractor
ENGINE
PULLEY
KEEPER BOLT
VIEWED FROM UNDERNEATH
Publicité
