Bertos MACROS 700 Série Mode D'emploi page 109

MODELS WITH ELECTRONIC CONTROLS
B-FLEX OPERATION (see fig. 12)
Switching on, adjusting, and switching off
When the bratt pan is switched off and the power cord is
connected to the mains, the A display will show "OFF. " To
switch the bratt pan ON, keep the B knob pressed for a few
seconds and the display will show the default temperature
(i.e. 50 °C) as the digit "°C" flashes.
To change the cooking temperature, quickly press down
the B knob and begin to rotate it. Once the display shows
the temperature you want, quickly press the B knob again
to memorize the new value or wait a few seconds: the
system will memorize the last value shown by the display.
When the set temperature is reached, the bratt pan will
emit a sound and the digit "°C" will be permanently shown.
Now, the unit will keep the temperature and will switch
on and off constantly to keep the temperature constant.
A sound will be heard every time the bratt pan reaches the
set temperature.
To switch the bratt pan off, hold down the B knob for a few
seconds and the display "A" will show the word "HOT" as
long as the bottom of the bratt pan tank is over 60 °C; once
the temperature is under 60 °C, the display will show "OFF".
Attention
The unit is equipped with the following safety device:
- if the H LED is off, it means that the safety thermostat has
been triggered.
In this case, the bratt pan doesn't work until the safety
device is restored.
PART REPLACEMENT
(SPARE PARTS)
Cut off the power from the appliance (remove the fuses).
To reach the parts more easily, remove the front panel.
Before removing the panel, remove the temperature
adjustment knob, the handle of load water tap and the
control handwheel of the cooking tilting pan.
WARRANTY CERTIFICATE
COMPANY NAME:
____________________________________________________________________________________________
ADDRESS:
____________________________________________________________________________________________________
POSTAL CODE:
___________
PROVINCE:
_______________
ATTENTION!
The manufacturer declines all responsibility for any inaccuracies in this handbook due to typing or printing errors.
The manufacturer reserves the right to make any changes that may be required without altering the basic features of the
product.
The manufacturer declines all responsibility in the event that the instructions given in this handbook are not fully
observed. The manufacturer declines all responsibility for any direct or indirect damaged caused by incorrect installation,
tampering, poor maintenance and negligent use.
TOWN:
___________________________________________________________________________
INSTALLATION DATE:
____________________________________________________________
MODEL.
_________________________________________
PART NUMBER:
________________________________
Replacement of heating elements
- Disconnect the power cables to the heating element/s.
- With the tilting pan models to facilitate the replacement,
rotate the tank to the maximum opening.
- Remove the sheet insulation protection by unscrewing
the tank fixing screws.
- Remove the heating element protection panel.
- Remove the heating element supporting plate from the
damaged heating element.
- Assembly the new heating element by following the
sequence in reverse.
Replacing the lights
- Disconnect the power supply cables.
- Remove the lamp.
- Assemble the new lamp by following the sequence in
reverse.
Replacing the operating thermostat or the safety
thermostat
- After removing the front panel, disconnect the power
supply cables.
- Remove the bulb, located at the tank bottom, from the
front side.
- Remove the thermostat by unscrewing the support
fixing screws.
- Assemble the new thermostat by following the
sequence in reverse.
Replacing the switch
- After removing the front panel, disconnect the power
supply cables.
- Replace the switch, unscrewing the support fixing
screws; the operating coaxial thermostat should have
been removed.
- Assemble the new switch by following the sequence in
reverse.
| 109
EN