Technical Features; Dimensions; Electrical Components; Maintainance And Cleaning - BORETTI BGR-88 Notice D'emploi

Technical features

Dimensions:

Fitted hobs
size BGR-88
size BGR-116
corner
RADIUS min. cm 67,5
RADIUS max. cm 112,5

Maintainance and cleaning

Cleaning the hob

Before you start cleaning the hob wait until the
rungs, burners and hotplates are cold and then,
for greater safety, turn the power off via the
main switch. Wash the enamelled, painted or
chromium parts with warm water and soap or
a mild, non-corrosive liquid detergent, avoiding
all abrasive substances. Do not leave acid or
alkaline substances (lemon juice, vinegar, etc.)
on for any length of time as they can ruin the
surface. If your hob is in stainless steel, use a
damp cloth and a suitable, non-abrasive pro-
duct, easily found on the market, or hot vine-
gar. Dry with a soft cloth or chamois leather.
NB: Do not steam clean.
WARNING: Keep the openings on the
triple burner clean. To do this, use a
piece of cotton wool soaked in a mild
non-abrasive and non-corrosive deter-
gent
44
width depth
cm 88 cm 51
cm 116 cm 51
45
Fig. 4

Electrical components:

Electronic ignition
Isolation category
Supply voltage

Cleaning the gas burners

Once the components are cold take the bur-
ners off and wash them with hot water and a
liquid detergent. Dry them thoroughly before
putting them back, checking that no openings
are clogged with dirt. The burners must be put
back properly otherwise it could lead to serious
combustion anomalies. The nozzle holders, Fig.
4, also need cleaning periodically, removing any
dirt that may have accumulated and suctioning
them, also checking that the gas outlet holes
are not clogged.
V.A. 0,6
I
230V 50 Hz
Pan support
Burner cover
Burner
Nozzle holder