Terminating A Charge / Discharge Process - ROBBE Power Peak C8 EQ-BID Notice D'utilisation

Power Peak ® C8 EQ-BID 180W
1. Connect the battery (in the case of a Lithium battery: connect the voltage sensor lead at
the same time), and check for correct polarity (see page 8).
2. Connect the BID chip or key.
3. Press the "MODE" button once: the charge process starts with a delay of about two
seconds. Alternatively a discharge process is initiated if you press the button twice,
while a discharge / charge process (cycle charge) is started if you press the button
three times.
The selected process can be stopped by pressing the same button again.
Note:
If you are using the BID system it is also possible to charge or recharge Lithium batteries
without connecting the voltage sensor lead, although this is not recommended.
12.

TERMINATING A CHARGE / DISCHARGE PROCESS

The charger terminates the charge or discharge process automatically; the internal pro-
cessor governs this action, taking into account the charge / discharge parameters. For
each battery type the charger employs the most suitable cut-off method. At the end of the
process the charger emits a sequence of beeps in accordance with the setting.
Operating Instructions
15
No.
8124