Faults; Error Codes - Pelgrim GVW855 Notice D'utilisation

No drying ( button)
This button switches off the drying programme at
the end of the programme. The dishes dry
exclusively from their own heat.

Error codes

Error codes can be shown on the display panel. You can reset error messages by operating the
programme selection button. If the error message remains on the display panel, proceed as indicated
below:
error code remedy
Code E1 This may be a temporary
The level switch for the defect. Start the appliance
water level is not again. If the display shows
functioning. the same code again,
phone the service
department.
Code E2 Turn the device off using
The aquastop has come into the main switch. Turn the
operation. device back on and restart
the program. If the identical
code is displayed again, call
the service department.
Turn the water tap off and
remove the plug from the
socket. Phone the service
department to remedy the
fault.
Code E3 This may be a temporary
A defect in the heating defect. Start the appliance
cycle. again. If the display shows
the same code again,
phone the service
department.
Code E4 This may be a temporary
Thermostat defective. defect. Start the appliance
again. If the display shows
the same code again, phone
the service department.
Half load ( 1 button)
/
2
With this button depressed, only the dishes in
the top basket are washed. The cutlery basket
can be placed on the right-hand side of the top
basket. The lower basket should remain empty.
error code remedy
Code E5 Close the door. The
Defect in the water supply. programme will start again
First check whether: at the point at which it was
– the tap has been turned interrupted.
on; Should the programme not
– the filter in the supply start again, set the
piping is clogged; appliance to low water
– the supply piping has pressure (see page 22). If
been constricted. this does not help either,
phone the service
department.
Code E6 Phone the service
Heating without water. department to remedy the
fault.
Code E7 Close the door. The
Defect in water discharge. programme will start again
First check whether: at the point at which it was
– the discharge hose has interrupted.
been constricted; Should the programme not
– the discharge hose is start again, phone the
obstructed. service department.
Code E8 Switch the machine off and
Fault in reading the then on again.
memory.
Code E9
Code for timer adjustment
by the service department.