CARE INTENSIVE LINE Mode D'emploi page 13

After the setting of "DISTANCE", press ENTER key, the CALORIES indicator light up and the LED indicator
light shines on the display of "CALORIES". The initial value of "CALORIES" is "0". Press direction keys to set
"CALORIES".
The TIME – DISTANCE – CALORIES can be cycle setting. After the target settings of TIME, DISTANCE and
CALORIES are determined, press the key "START", and this mode starts to operate.
During the exercise, press "ENTER" to switch, fix and display "SPEED - TIME – DISTANCE / RPM -
CALORIES - WATTS" screen.
During the exercise, press "PAUSE", and the program will pause. The TIME / DISTANCE / CALORIES display
will show motion data by turns.
After pause, if you want to continue the previous exercise, press "START" and the program will continue
accumulate with the TIME/DISTANCE/CALORIES data before press pause.
Press "STOP" could stop the program, and press "STOP" again will clean the exercise date and go back to
the main program selecting page for MANUAL/ PROGRAM/ USER/ HRC/ WATTS.
Dot matrix displayed messages during exercise:
During exercise, if RPM has not been reached to 30 , screen will appear twice the rolling string of "RPM↑" for
5 seconds. After the message, if the RPM still not reach to 30, program will be paused and screen will appear
twice the rolling string of "PAUSE" for 5 seconds.
USER mode
Press the direction keys to select USER.
Press Enter to get into the target value setting page.
After press ENTER, the TIME indicator light up and the LED indicator light shines on the display of "TIME".
The initial value of "TIME" is "0:00". Press direction keys to set "TIME".
After the setting of "TIME", press ENTER, the DISTANCE indicator light up and the LED indicator light shines
on the display of "DISTANCE". The initial value of "DISTANCE" is "0.0". Press direction keys to set
"DISTANCE".
After the setting of "DISTANCE", press ENTER, the CALORIES indicator light up and the LED indicator light
shines on the display of "CALORIES". The initial value of "CALORIES" is "0". Press direction keys to set
"CALORIES".
The TIME – DISTANCE – CALORIES can be cycle setting. After the target settings of TIME, DISTANCE and
CALORIES are determined, press the key "START", and this mode starts to operate.
If the user want to do the operating program of graphical editing:
Enter into "USER" program, the TIME indicator light up and the LED indicator light shines on the display of
"TIME". The initial value of "TIME" is "0:00".
For editing of graphs, press "ENTER" for 3 seconds, then the first row on the Dot Matrix flicked. At the TIME
display chart will show code S-1 to show the editing.
Press DIRECTION keys to set "LEVEL". After completed setting is confirmed, press "ENTER" to setting
program of LEVEL on the next row.