Noise/Vibration Information; Declaration Of Conformity - Bosch AHS 400-24T Notice Originale

OBJ_BUCH-2115-001.book Page 12 Friday, December 6, 2013 11:19 AM
12 | English
Hedgecutter
Article number
Rated power input
No-load stroke rate
Tooth opening
Cutting length
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Please observe the article number on the type plate of your garden product. The trade names of the individual garden products may vary.

Noise/Vibration Information

Measured sound values determined according to EN 60745.
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according to
h
EN 60745:
a
h
K
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.

Declaration of Conformity

We declare under our sole responsibility that the product described under "Technical data"
is in conformity with the following standards or standardization documents: EN 60745 ac-
cording to the provisions of the directives 2011/65/EU, 2004/108/EC, 2006/42/EC,
2000/14/EC.
2000/14/EC: Guaranteed sound power level
Conformity assessment procedure according to Annex V.
F 016 L81 083 | (6.12.13)
AHS 650-24ST AHS 6000 PRO-T AHS 7000 PRO-T
3 600 ... H48 4..
W 600
-1
min 1400
mm 24
mm 650
kg 4.2
/II
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
H48 A.. H48 B..
700 700
1500 1500
34 34
600 700
4.3 4.5
/II /II
3 600 ... H48 0.. H48 A..
H48 1.. H48 B..
H48 2..
H48 3..
H48 4..
dB(A) 77 78
dB(A) 98 99
dB 3 3
2
m/s 3.7 4.7
2
m/s 1.5 1.5
3 600 ... H48 0.. H48 A..
H48 1.. H48 B..
H48 2..
H48 3..
H48 4..
dB(A) 101 102
Bosch Power Tools