Intended Use; Technical Data; Noise/Vibration Information; Mounting And Operation - Bosch AMW FS Notice Originale

OBJ_BUCH-2376-002.book Page 13 Thursday, October 20, 2016 11:53 AM

Intended Use

This multi-tool attachment can only be operated by the power
unit AMW 10.
The machine is intended for cutting of grass,light and heavy
vegetation, brambles and bushes in domestic and hobby gar-
dens.

Technical Data

Brush Cutter Attachment
Article number
No-load speed
Cutting width
Weight according to EPTA-
Procedure 01:2014
Serial number

Noise/Vibration Information

The following information is applicable for the attachment op-
erated by the power unit.
Sound emission values determined according to
EN 50636-2-91.
Typically the A-weighted noise levels of the product are:
Sound pressure level 88 dB(A); sound power level 99 dB(A).
Uncertainty K =1 dB.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 50636-2-91:
2 2
a =3.0 m/s , K=1.8 m/s .
h
Troubleshooting
Problem Possible Cause
Motor runs but blades re- Multitool-attachment not properly connected
main stationary to power unit
Machine does not cut Cutting blade damaged
Increased vibration Cutting blade damaged
Debris build up on cutting head
Blade nut loose
Cutting blade incorrectly fitted
Bosch Power Tools

Mounting and Operation

The numbering of the figures refer to the illustrations of the
machine on the graphics page.
Action
Delivery scope
Mounting the blade guard
Attaching the blade
AMW FS
Disassemble the handle
3 600 HA3 E00
Mounting the barrier/operating
advice for right-handers
-1
min 8000
Mounting the barrier/operating
cm 23
advice for left-handers
Fitting the multi-tool attachment
kg 1.6
Attaching the shoulder strap
see type plate on the
garden product
Working advice
Cleaning
Storage
Selecting accessories
Figure
1
2
3
4
5
6
7
8
9
10
11
12
Corrective Action
Check for correct assembly
Replace the blade (always wear protective
gloves)
Replace the blade (always wear protective
gloves)
Clean cutting head and remove debris
Tighten nut ensuring the blade, rider plate and
dome washer are all present and central (al-
ways wear protective gloves) (see figure 3)
Remove cutting blade and refit in a fully central
position. Use guide rings on the blade to ensure
correct central alignment
F 016 L81 371 | (20.10.16)
English | 13
Page
202
202
203–204
205
205
206
206
207
207
208
208
208