AudioSonic CD-576 Mode D'emploi page 9

VARIOUS PLAY MODES
SKIPPING TRACKS AND SEARCHING BETWEEN TRACKS
• Press SKIP UP button once to skip the current track and play the next track, press
this button continuously to go to corresponding tracks ahead;
• Press SKIP DOWN button once to skip the current track and go back to the
previous track, press this button continuously to go back to corresponding tracks
at back. Press and hold SKIP buttons to initiate high-rate scanning between tracks;
release one of them to begin playback of music at normal speed.
REPEAT MODES
• Press MODE button once in play mode to repeat the current track; the LCD shows
the icon for single track repeat.
• Press MODE button twice in play mode to repeat tracks on stored on this storage
media (USB/MMC card) as a whole; the LCD shows the icon for all tracks repeat.
Press MODE button thrice to repeat tracks in the current folder as a whole; the LCD
shows the icon for DIR repeat.
RANDOM PLAY
Press MODE button for the fourth time in play to activate random playback
immediately; the player will pick up tracks in a random sequence for playback after
PLAY/PAUSE button is pressed. You may press STOP button to exit random play mode
and press PLAY/PAUSE button to resume normal playback.
INTROSCAN PLAY
Press MODE button for the fifth time in play mode to activate introscan playback
immediately; the player will pick up tracks for playback of the first 10 seconds of each
track in a sequential order after PLAY/PAUSE button is pressed. You may press MODE
button once again to exit introscan play mode and return to normal playback from
the track it's arrived at.
AUXILIARYIN
Your player can be used as a power amplifier to playback the programs from portable
radio, TV set or MP3 player or whatever provided this appliance is so designed that
audio signal may be produced through a LINE-OUT jack or the like. Observe the
following steps to connect the player to another appliance:
1. Power the player on using the supplied AC Power Cord.
2. Slide Function Switch to CD/MP3/Aux position.
3. Connect the appliance into the player's AUX in socket with the supplied LINE OUT
cable of the appliance.
4. Power on the appliance and begin play.
Easy job, right? At this time you will be able to hear the sound produced from the
programs the connected appliance is broadcasting.
EQ SELECTION
Press Program/EQ button continuously during disc playback mode to select EQ
sound effects among POP, ROCK, CLASS, JAZZ, BASS and NORMAL.
IMPORTANT
Note: Although this CD player can read CD-R, CD-RW and MP3 discs - in addition to
normal CD's - the playability of CD-R, CD-RW and MP3 discs may be affected by the
type of software that was used to create the discs, as well as the quality and condition
of the blank media you are using. 100% playability cannot be guaranteed. This is not
an indication of a problem with the player.
IMPORTANT
• The USB port of this product is fully compatible with the USB 1.1 and 2.0 standard.
If MP3 players connected to this port are not written in compliance with the
official USB 1.1 or 2.0 standard it may occur that those MP3 players do not work on
this port. This is not a defective of this product.
• The MP3 player does not comply with the official USB 1.1 or 2.0 standard.
Instruction Manual EN
9