Load A Disc; Play A Disc - AudioSonic CD-576 Mode D'emploi

NOTES:
• If a particular FM (STEREO) station is weak, or you hear too much background
noise, try moving the band selector switch to the FM (MONO) position. This can
often result in a much clearer reception.
• When the band selector switch is set to FM STEREO and a stereo broadcast is on
the air. The FM ST. indicator will light up.
STEREO PHONES JACK
A stereo phones jack has been provided on the side of the player so that you can
listen without disturbing others. To use this jack, plug in the headphones/ earphones
(NOT INCLUDED) and adjust the VOLUME control to a preferred level.
NOTE:
When external headphones/earphones are connected, the speakers will be muted.
HANDLING AND MAINTENANCE OF ADISC
Follow the instructions below to handle and maintain your disc in order that long
time and trouble free performance can possibly be obtained:
• Ensure not to caress the rain bow side of the disc; handle the disc by the edge.
• Long time exposure to sunshine, high temperatures and humidity will damage the
disc. And keep storage area clean.
• Avoid sticking labels on both sides of a disc. Writing with pointed articles on the
disc should be strictly avoided.
• Clean the disc wiping the centre and then working out to the edge with a dry &
soft cloth or a disc brush. Avoid any cleansing lotion or chemical eradicator.
• Store them in their cases when they are not to be used.
CLEAN FROM CENTER TO EDGE
DO NOT STORE NEAR HEAT
6
Instruction Manual

LOAD A DISC

1. Open the CD door by the Door open area.
2. Load a disc on the disc tray with the label side facing up.
3. Close the CD door.

PLAY A DISC

1. Slide the Function switch to CD/MP3/AUX position.
2. Follow the steps above to load a disc.
3. The player begins reading disc immediately the CD door is closed, "READING"
shows in the LCD.
4. When the disc is successfully read, TOC (total of contents) shows in the LCD and
playback follows with the first track.
5. Press Play/Pause button once to halt music playback, the elapsed time of the
current track flashes and "PAUSE" appears on the bottom of the LCD to indicate
the player in Pause mode; press Stop button to cease music playback. The LCD
shows the TOC again with "STOP" on the bottom.
SKIP TRACKS AND SEARCH FOR A SPECIFIC POINT TO PLAY
1. Press once the SKIP/SEARCH up button in music play to skip to the next track. To
skip to a specific track ahead, press this button several times.
2. Press once the SKIP/SEARCH down button in music play to skip to the previous
track. To skip to a specific track at back, press this button several times.
3. Press +10/ALBUM button once in play to skip to the track 10 tracks ahead, twice to skip
to the track 20 tracks ahead. You can reach the last track of the disc using this button.
4. Hold the SKIP/SEARCH up button in music play to search at quick rate for a specific
point to play.
5. Hold the SKIP/SEARCH down button in music play to search at quick rate for a
specific point to play.