LINEACCESSORI Meta Voice Manuel D'utilisation page 6

Introduction
Dear Customer,
Before you start reading the operating instructions on the following pages, we would like
to congratulate you for choosing Meta Voice. It is our pleasure to give you some general
indications that you should fi nd useful for getting to know how your new hands free sy-
stem works.
Meta Voice is a hands free appliance that uses Bluetooth technology.
The main reason for the creation of Bluetooth technology is its capacity to enable dialo-
gue and interaction between diff erent appliances (telephones, printers, notebooks, PDA,
HiFi systems, TVs, computers, PCs, mobile phones, electrical appliances, hands free sy-
stems...) without the need for wires to connect things generally known as wireless to-
gether, provided the various paired appliances are located at a distance (or range) of no
more than 5 m from one another.
Wireless refers to the type of communications, to monitoring and to a series of controlling
systems where the signals travel through space and not along wires or transmission cables.
In a wireless system, transmission mainly takes place by radio frequency (RF).
Bluetooth technology was, therefore, specifi cally designed so that small appliances can
communicate with one another without wires. The key concept that inspired this techno-
logy was that of completely eliminating the wires needed for communications between
appliances. Meta Voice is classifi ed as Bluetooth 2.1, class 2.
Operating modes
The way the system operates is described below.
Always refer to the operating manual for your mobile phone for pairing and recogni-
tion procedures.
The system is operational when the dashboard is switched on, unless the dashboard is
switched off when a telephone call is being taken. In this case, the system will remain ope-
rational so the call can continue for a maximum of 10 minutes more.
Any activity involving interaction with your mobile phone must be done when the vehicle
is not in motion.
The LED identifi es the various stages of activity by changing its status accordingly when
the dashboard is on.
• Fast fl ashing (1sec): the system is searching to pair up to a telephone.
This phase lasts 60 sec. at most, after which the led goes out and remains off .
• Lit without fl ashing: the system is connected up to a telephone.
Pressing the button will result in a tone being heard through the speaker, regardless of the
operating status of the system.
Pairing
Pairing: procedures enabling the reciprocal identifi cation between the mobile phone and
the hands free set and enabling subsequent recognition.
In order to use the hands free set, the telephone and the hands free set must be paired
together.
5040279200 Man.Meta Voice FT/LA/6 6 5040279200 Man.Meta Voice FT/LA/6 6
EN
26-04-2010 13:37:12 26-04-2010 13:37:12