Monacor PA-1140RCD Mode D'emploi page 10

GB 4 Installation of the Insertion Module
WARNING Prior to the installation of the insertion
disconnect the mains plug of the ampli-
fier or of the basic insertion unit from the
mains socket. Otherwise there is an
electric shock hazard.
1) Remove the housing cover of the amplifier or of the
basic unit.
2) Screw off the cover for the insertion compartment
on the front side of the amplifier or of the basic unit.
Install the insertion and tighten it with screws.
3) Connect the bare three-pole line of the amplifier or
of the basic unit to the pin housing of position c (see
fig. 2). This allows to supply the insertion with 17 V
and to feed the audio signal to the amplifier.
4) If required, two further audio outputs are available:
balanced mono output at the connection d
unbalanced stereo output at the connection e
5) For mounting the supplied antenna connections on
the rear side of the amplifier/basic unit, unscrew the
cover panel (fig. 3) or remove the cover plate
(fig. 4). Insert the antenna connecting PCB into the
opening and tighten it with screws.
6) Connect the line of the inserted antenna PCB to the
five-pole pin housing of position a.
7) The insertion PA-1140RCD has a storage battery
so that the stations also remain stored with the unit
switched off. The storage battery is deactivated in
the factory to prevent successive discharge before
installation. To activate the battery, set the jumper b
to position ON.
To deactivate the battery again (e. g. if stored for
a longer time), set the jumper b to position OFF
again.
8) Close the amplifier or the basic unit with the hous-
ing cover and connect the reception antennas to the
screw connections of the antennas. Pay attention to
the lettering on the amplifier or on the basic unit:
AM+GND for medium wave antenna
FM 75 Ω for FM antenna with 75 Ω connection
cable
300 Ω for FM antenna with 300 Ω connection
cable
10
5 Operation
1) Switch on the amplifier or the basic unit with the
mains switch and the insertion module with the
POWER button (2).
2) Adjust the desired volume with the volume control
LEVEL (17).
3) To switch off, press the POWER button again.
5.1 Operation of the CD / MP3 player
It is possible to replay audio CDs including those you
have burnt yourself (CD-R) and CDs with titles in the
MP3 format. In case of rewritable CDs (CD-RW), how-
ever, problems may occur while replaying depending
on the CD type, the CD burner and the burning pro-
gramme used.
Via the USB port also MP3 files can be replayed
from a USB flash drive.
5.1.1 Replaying music titles
1) Insert a CD with the lettering facing upwards so far
into the slot (5) until it is automatically retracted. If
there is already a CD in the unit, the display shows
the symbol .
To change a CD, press the button EJECT (1).
The CD is ejected. If the CD is not removed, the
unit retracts the CD after a few seconds.
2) Alternatively or additionally, a USB flash drive can
be inserted into the USB port (10).
3) After loading, the first title starts. For standard
audio CDs the display shows the title number and
the time already played (min. : sec.).
For titles in the MP3 format the file name passes
through the display, then the title number is shown
behind the letter "T". When the button DISP (12) is
pressed repeatedly, information about the title of
the music piece, the album, the artist etc. (ID3 tags)
can be displayed. If no ID3 tags are available, the
display shows NO ID3.
Note: When replaying from a CD or a USB flash drive
and the button DISP is pressed, also information about
the station adjusted are displayed, see chapter 5.2.3,
paragraph "Information". Therefore, actuate the button
DISP repeatedly until the desired information is dis-
played.
4) After replaying the last title, the unit restarts with the
first title (continuous replay).
5) To interrupt the replay, press the button
display indicates S-PAUSE. When pressing the
button again, the replay is continued.
6) To switch between the replay from the CD, the USB
flash drive and the radio reception, press the button
MODE (3).
(6). The