Pioneer DRM-7000 Mode D'emploi page 14

TO AVOID PROBLEMS
÷ In order to allow use of the DVD-R7783, changer firmware revision
11. DVD-R/RW drive
unit DVD-R7783
÷ When the DVD-R7783 is installed, the Power supply unit DRM-
÷ When using the DRM-ULV16, the SE SCSI bus must be limited to
12. LVD SCSI
interface unit
DRM-ULV16
÷ When the DRM-ULV16 is installed, the Power supply unit DRM-
14
<DRC1285>
En
Issue
must be 1.25 or later (for either DRM-7000 or DRM-3000).
If a firmware revision earlier than 1.25 is used, the changer's device
driver may not operate correctly. Be sure to update your firmware to
Rev. 1.25 or later before use.
For details regarding updating of firmware, consult your Pioneer
service center, or retail dealer.
PW701 cannot be used.
the following conditions. Usage is not supported beyond these lim-
its:
Total bus length including internal to device: 3 m or less
Number of drives connected on bus: 3 or less *
* Under these conditions, a maximum of 3 SE drives can be
installed on a single changer. In addition, due to the limitations on
cable length, drives should be installed in the rear bays #1 to #3.
PW701 cannot be used.
Potential Malfunction/Error
÷ Changer's device driver
malfunctions
÷ Disc write/playback error
÷ Disc write/playback error
÷ SCSI transmission error
÷ Disc write/playback error