Safety Instructions; General Instructions; Introduction; Working Principle - THERMOBILE AGA 100 Manuel De L'utilisateur

English
1

SAFETY INSTRUCTIONS

1.1 Pictograms in this manual
Caution
Indicates risk of damage to the
appliance.
Warning
Indicates a dangerous situation that
may lead to death or serious injuries.
Warning
Always switch off power when
performing maintenance or repairs on
the convector heater!
Hot
Some surfaces may be hot! Wait until
these parts have sufficiently cooled
down before performing
maintenance.
Suggestions and tips to facilitate the
specified tasks or actions.
1.2 Pictograms on the heater (fig. 2)
A Identification plate
B Adjustment data for gas
C User instructions
D User instructions
1.3 Use this product for its intended
use
The heaters described in this manual are
suitable for heating using natural gas.
The heaters have been designed for heating
poultry houses, greenhouses and
polytunnels, and for drying agricultural
produce.
16
1.4
2
2.1
These heaters are directly-fired natural gas
heaters with a combustion air fan (only AGA
102) and a hot air fan.
The heaters are equipped with a connection
for a room thermostat
The hot air heaters have been tested at sea
level at a temperature of 20 °C.
2.2
After the heater is switched to the "heat"
position, the fans for the hot air and the
combustion air start (the AGA 100 only has a
hot air fan, which also supplies the
combustion air supply). The electrical ignition
is activated and, after some time, the gas
control block connects the gas supply to the
burner.
40.020.954 - rev. 05 - 2017

General instructions

Warning
• Read this manual carefully
before using the heater.
• Keep this document with the
heater.
• Follow the described procedures.
• Never lean against the heater.
• Keep highly inflammable
materials at a minimum distance
of 3 m from the heater:
• Do not put the heater on an
inflammable floor.
• Make sure there is enough air for
good combustion.
• Only perform repair and
maintance work when the
convector heater has sufficiently
cooled down, and after removing
the plug from the socket.
• Make sure there is fire-
extinguishing equipment near the
heater.
• The gas connection must comply
with the applicable local
regulations.

INTRODUCTION

Purpose

Working principle

AGA 100/102