Alcad MVC-130 Manuel D'utilisation page 12

ENG - 12 VIDEODOOR ENTRY SYSTEM MONITOR
OPERATION OF THE SYSTEM
SYSTEM ON STAND-BY
In this status the monitor can't perform any function, or if it is powered independently, you
can only consult the recordings and enter the configuration menu . If you press any of
the buttons, the monitor beeps busy ringtones and the autoswitch-on button blinks until
the system changes to stand-by mode.
NO CALL. MONITOR ON STAND-BY
If the monitor does not receive a call the functions of door opening and of communication
with the street entrance panel are disabled. In this state, it is possible to activate the automatic
switch-on feature or to access the configuration menu and recordings menu .
RECEIVING A CALL. MONITOR ACTIVATED
An audio signal from the monitor will be heard when a call is received from the entrance
panel. Following the screen will switch on and show the image of the person who has called.
You have 30 seconds to answer.
When the communication button , is pressed, communication is established with the
person who is calling. Conversation time is limited to 60 seconds.
A few seconds before the conversation time elapses, you will hear a series of beeps. You can
prolong the conversation time from your own dwelling by pressing the conversation button
twice, or, from the entrance panel, by having the visitor call again. The conversation will
end when the communication button is pressed once, or when the conversation time runs out.
The system will then revert to being on standby.
Push the lock release button to open the door and allow the person access to the property.
Time limit to
answer the call
Time limit for
30 seg.
conversation
60 seg.
Ring tone
Panel Call
made to flat
Picking-up
Extending the time limit
for conversation
+
Fin de conversación
Opening the door