Electrolux EEC5700 Notice D'utilisation page 30

30 www.electrolux.com
Problem
The oven does not heat up. The fuse is released.
The lamp does not operate. The lamp is defective.
The display does not show
the time during the off sta-
tus.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C3".
The display shows "F102".
The display shows an error
code that is not in this ta-
ble.
Possible cause
The display is deactivated.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
• You did not fully close
the door.
• The door lock is defec-
tive.
There is an electrical fault.
Remedy
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
Replace the lamp.
Touch and at the
same time to activate the
display again.
Adjust the temperature if
necessary. Follow the ad-
vice in the user manual.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
Fully close the door.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact
the Customer Care De-
partment.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, con-
tact the Customer Care
Department.