Scale Settings; Auto-Off; Zero Tracking Range; Zero Display Range - OHAUS Ranger Count 1000 Série Guide De L'utilisateur

EN-12

5 SCALE SETTINGS

Long-press TARE to enter into the user-selectable scale settings (Setup mode).
In Setup mode:
o Press Sample to step through available settings
o Press Tare to accept the displayed setting and proceed to the next Setup
parameter
Press C at any time to exit from the Setup mode.
Re-start the scale after changing settings in the Setup mode
The following parameters are available:

5.1 Auto-Off

Sets the period of inactivity before
the scale automatically turns off.
The following settings are available:
0 = Off, 2, 5, 8 (minutes)

5.2 Zero Tracking Range

Sets the range in which the zero
reading is maintained.
The following settings are available:
0 = Off, 1 = 0.5d, 2 = 1d, 3 = 2d,
4 = 3d
(d = scale division)

5.3 Zero Display Range

Sets the range in which the Zero
indication turns on.
The following settings are available:
0 = Off, 1 = 0.5d, 2 = 1d, 3 = 2d,
4 = 3d
(d = scale division)

5.4 Filtering

Sets the level in which the Stable
indication turns on; the higher the
setting, the faster stabilization time.
The following settings are available:
0, 1, 2, 3, 4, 5 (level)
Weight g
Piece Weight
0..
Default Setting
Weight g
Piece Weight
2..
Default Setting
Weight g
Piece Weight
3..
Default Setting Zero Display Range
Weight g
Piece Weight
1..
Default Setting
Ranger Count 1000 Series
Count
g/pc
------.
A.Off
Auto-Off Internal Count
(disregard)
Count
g/pc
------.
trAC
Zero Tracking Internal Count
Range (disregard)
Count
g/pc
------.
2Ero
Internal Count
(disregard)
Count
g/pc
------.
Filt
Filtering Level Internal Count
(disregard)
pcs
pcs
pcs
pcs