Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Disconnect the terminal by pulling it.
1
Remove the crank cap by loosening the screws with a
screwdriver. Rest the tool on the table with the bit end
pointing upwards. This will allow the old grease to collect
inside the crank housing.
Wipe out the old grease inside and replace with a fresh
grease (30 g; 1 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the
specified amount of grease (approx. 30 g; 1 oz) can
cause faulty hammering action or tool failure. Fill only
with the specified amount of grease.
1
Reinstall the crank cap and secure with the screws.
Connect the terminal and reinstall the handle.
1
004491
1. Terminal
004492
1. Screw
1
2. Crank cap
2
004493
1. Hammer grease
004494
1. Terminal
CAUTION:
•
Be careful not to damage the terminal or lead wires
especially when wiping out the old grease or install-
ing the handle.
•
Whenever reinstalling the handle, use the two short
screws for the upper side and two long screws for
the lower side.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
•
These accessories or attachments are recom-
mended for use with your Makita tool specified in
this manual. The use of any other accessories or
attachments might present a risk of injury to per-
sons. Only use accessory or attachment for its
stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
Bull point
•
Cold chisel
•
Scaling chisel
•
Grooving chisel
•
Clay spade
•
Rammer
•
Bushing tool
•
Ground rod adapter
•
Bit grease
•
Hammer grease
•
Side handle (auxiliary handle)
•
Safety goggles
MAKITA LIMITED ONE YEAR WARRANTY
Warranty Policy
Every Makita tool is thoroughly inspected and tested
before leaving the factory. It is warranted to be free of
defects from workmanship and materials for the period of
ONE YEAR from the date of original purchase. Should
any trouble develop during this one year period, return
the COMPLETE tool, freight prepaid, to one of Makita's
Factory or Authorized Service Centers. If inspection
shows the trouble is caused by defective workmanship or
material, Makita will repair (or at our option, replace)
without charge.
This Warranty does not apply where:
•
repairs have been made or attempted by others:
•
repairs are required because of normal wear and
tear:
•
the tool has been abused, misused or improperly
maintained:
7
EN0006-1
Publicité
Table des Matières
