Velleman CAMRFM3 Notice D'emploi page 5

Fea t ures
4.
• converts audio/video line level signals from a DVD player, video game
system, camcorder or other device to an RF signal and adds this signal as
extra channel on the antenna cable to enable multiple TV connections
• easily distribute video-signals over an RF network
• connects one audio/video device to a television set
• selection between different video channels
Overview
5.
Refer to the illustration on page 2 of this manual
1
antenna/cable input
2
TV/VCR/cable output
3
power input
4
SCART input
5
SCART output
6 a
video input
I nst a lla t ion
6.
• Choose the appropriate location to insert the RF modulator into the
antenna/cable circuit. Keep in mind that only the devices physically located
behind the RF-modulator in the cable network will be able to receive the
extra inserted channel.
• Connect an input device to the SCART input [ 4 ] or video [ 6 a] & audio
inputs right [ 6 b] and left [ 6 c] . Do not sw it ch it on ye t .
• Connect the connector coming from the antenna or cable television input to
the antenna/cable input [ 1 ] .
• Connect the TV/VCR/cable output [ 2 ] to a TV set or a cable network if
present inside the house.
• Make sure the included power adaptor is compatible with your mains. Plug
the DC power adaptor into the power input [ 3 ] . Only use the included
adaptor or an adaptor with identical specifications.
• An extra device can be connected to the SCART output [ 5 ] . Note that this is
only a loop through connector thus receiving only the signal from the
connected input device. Other TV channels are not available at this output.
• Switch on the RF modulator by switching the power on/off switch [ 7 ] to
the ON position. The channel display [ 1 0 ] lights up and shows the
current channel on which the input signal will be broadcasted.
04/02/2009
CAM RFM 3
6 b
audio in - R
6 c
audio in – L
7
power on/off switch
8
channel down button
9
channel up button
1 0
channel display
5
®
Components nv
©Velleman