Customer Service; Replacing The Lamp; Installation - Electrolux GT223 Notice D'utilisation

60 www.electrolux.com
Problem

8.2 Customer Service

If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your appliance
which can be found either on the
guarantee certificate or on the rating plate
located on the external right side of the
appliance.

8.3 Replacing the lamp

WARNING!
Do not remove the lamp
cover at the time of
replacement. Do not operate
the freezer if the lamp cover
is damaged or missing.

9. INSTALLATION

WARNING!
Refer to Safety chapters.
9.1 Positioning
CAUTION!
If you are discarding an old
appliance that has a lock or
catch on the lid, you must
ensure that it is made
unusable to prevent young
children being trapped inside.
Possible cause
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The ActionFreeze function
is switched on.
Products to be frozen are
placed too closely to each
other.
1. Disconnect the mains plug from the
2. Replace the used lamp with a new
3. Connect the mains plug to the mains
4. Open the lid. Make sure that the lamp
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
Solution
Defrost the appliance.
Open the door only if nec-
essary.
Refer to "ActionFreeze
function".
Make sure that there is cold
air circulation in the appli-
ance.
mains socket.
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
socket.
comes on.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C