System Settings - Pioneer DEH-X8800BHS Mode D'emploi

Menu Item
A-EQ & TA
[ON], [OFF]
SAVE SETTINGS
[YES], [CANCEL]
LOAD SETTINGS
[AEQ SETTING], [SOUND
SETTING]
BASS BOOST
[0] to [+6]
LOUDNESS
[OFF], [LOW], [MID], [HI]
AUTO LV CTRL
[OFF], [MODE1], [MODE2]
SLA
[+4] to [–4]
*1 Not available when [SW] is selected in [REAR-SP] in the INITIAL settings (page 6).
*2 Not available when [FUL] is selected in [REAR-SP] in the INITIAL settings (page 6).
22
En
Description
Set the auto-adjusted equalizer to suit the
vehicle's acoustics. To use this function, the
vehicle's acoustics must be measured in advance
(page 18).
Select [OFF] to manually adjust the equalizer
curve.
Save to later recall the following sound settings
at their current values: [CROSSOVER], [SPEAKER
LEVEL], [EQ SETTING], [POSITION], [TIME
ALGNMNT], [BASS BOOST], [SUBWOOFER].
Load the auto EQ setting or the sound settings.
• [AEQ SETTING] is only available when you have
already performed auto TA and EQ (page 18).
• [SOUND SETTING] is only available when you
have already performed [SAVE SETTINGS].
Select the bass boost level.
Compensate for clear sound at low volume.
Adjust the difference in volume levels among
sources or audio files automatically.
Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
• When making a USB connection, set USB, iPod,
PANDORA, ANDROID, SPOTIFY, and APP.
• When making a Bluetooth connection, set BT
AUDIO, iPod, PANDORA, ANDROID, SPOTIFY,
and APP.

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
CLOCK SET
12H/24H
[12H], [24H]
BEEP TONE
[ON], [OFF]
INFO DISPLAY
[SOURCE/BTINFO], [SOURCE/
SPEANA], [CLOCK/BTINFO],
[CLOCK/SPEANA], [LEVEL METER],
[SPEANA], [OFF]
DOT DISPLAY
[SPEANA], [ICON]
AUX
[ON], [OFF]
BT AUDIO
[ON], [OFF]
SPOTIFY
[ON], [OFF]
BT MEM CLEAR
[YES], [CANCEL]
Description
Set the clock (page 6).
Select the time notation.
A beep can be heard when any button is pushed.
Select [OFF] to disable this function.
Display the item on the sub information display.
• When [SOURCE/SPEANA] or [CLOCK/SPEANA] is
selected, display the antenna instead of the
speana on the radio source.
Select [SPEANA] or [ICON] to appear on the left
side of the display.
Set to [ON] when using an auxiliary device
connected to the unit.
Set the Bluetooth signal on/off.
Set to [ON] when using the Spotify function.
Clear the Bluetooth device data (device list, PIN
code, call history, phone book, preset phone
numbers) stored in the unit.
[CLEARED] appears when data is successfully
deleted.