Cleaning And Storage - DS Produkte MJ1402 Mode D'emploi

EN
Cleaning windows and other smooth surfaces
1. Fill the spray bottle (11): Twist the spray head off of the spray bottle and fi ll the bottle
with cleaner and water according to the manufacturer's data (fi ll volume: max. 300 ml).
c
b
9. Switch the device on and vacuum the cleaning liquid off of the surface by pulling the
device down from the top.
10. The next steps are the same as when using the other suction nozzles (see above).
Using the telescoping pole
1. Connect the two parts of the telescoping pole so that the catch on the handle bar (13)
audibly locks into the designated opening on the extension bar (14).
2. Insert the telescoping bar in the opening (7) on the bottom of the main unit. The catch
must also audibly lock into the designated opening in this case.
3. To disconnect the telescoping pole from the main unit, push the catch and pull the
telescoping pole out.
4. Push the catch on the handle bar to release it from the extension bar.

Cleaning and storage

ATTENTION!
• Empty the waste water tank after every use or once the maximum fi ll level (mark) is
reached (see chapter "Emptying the waste water tank and cleaning the fi lter").
• After every use, clean the fi lter to prevent the suction power from diminishing and to
prevent the motor from overheating.
• Prior to each cleaning, switch the device off and make sure that it is not connected
to the mains supply.
2. Push the wiping adapter (a) onto the spray head from the
back. It must audibly lock into place.
3. Firmly fi t the wiping cover on the wiping adapter and se-
a
cure it with the Velcro fastener.
4. Close the bottle again.
5. Make sure that the spray head (c) is open: If the spray
head is set to OFF, turn it to Spray or Stream.
6. Spray the cleaner evenly onto the surface you intend to
clean. Push the spray lever (b) on the bottle.
7. Loosen the dirt with the wiping cover.
8. Insert the nozzle with the squeegee lip in the suction open-
ing of the device.
22