DS Produkte MJ1402 Mode D'emploi page 23

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Keep the main unit, charger and cord away from water or other liquids in order to
prevent electrical shocks. When cleaning, make sure that no liquids penetrate the
main unit. Only the waste water tank, the nozzle insert, the insert, the fi lter and the
suction nozzles may be cleaned with water. They must be completely dry before be-
ing inserted back in the device.
The fi lter is not suitable for the washing machine, dishwasher or dryer! Only air dry
the fi lter; do not in any case use a hair dryer.
Do not use any abrasive or scouring cleaners or cleaning pads to clean the device
and accessories. They could damage the surface.
If needed, clean the casing of the main unit with a damp, soft cloth. Dry it off with a
soft cloth.
Regularly remove hair and lint from the brush nozzle.
After every use, wash the wiping cover according to the washing instructions.
Check the charger and mains cord regularly for damage.
Keep the device operational. Charge the rechargeable battery battery after every use
(see chapter "Charging the rechargeable battery").
The fi lter may discolour over time. This is normal and does not affect the functionality.
If, however, it is damaged or worn, it must be replaced. You can reorder a new fi lter at
www.service-shopping.de.
Emptying the waste water tank and cleaning the fi lter
1. Switch the device off.
2. Carefully take the waste water tank off of the main unit (see chapter "Removing /
inserting the waste water tank").
3. Pull the insert and fi lter out of the waste water tank.
4. If you have vacuumed up dry dirt, empty the waste water tank in a garbage bin. Tap
out the insert and fi lter over the garbage bin. If wet dirt is located in the waste water
tank, rinse these parts off under running water.
Closed
Open
6. Screw the nozzle insert off of the waste water tank and clean it under running water.
7. Allow all parts to air dry completely before assembling them. ATTENTION: Do not in
any case put the fi lter and insert back in place if they are still wet. Reverse the
steps to assemble them.
8. Store the vacuum cleaner in a cool, dry, indoor room that is not accessible to children
and animals.
23
5. Take the fi lter out of the insert by turning it counterclock-
wise. Wash the fi lter with warm water and a mild cleaner.
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Z 02220

Table des Matières